Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1) › from 2021.02
RM33A0E _51 Engine / Hybrid System _098626 M20A-FKS ENGINE CONTROL _0462110 AIR FUEL RATIO SENSOR(for Sensor 1) A

M20A-FKS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor (sensor 1)

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89467B 2.REMOVE AIR FUEL RATIO SENSOR

CAUTION:
A344783

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A443529

Disengage the 4 wire harness clamps.


b.

Disconnect the air fuel ratio sensor connector.


c.
A443530

Remove the bolt and wire harness clamp bracket from the camshaft housing sub-assembly.


d.
A443531N01
1.74,1.042 2.042,1.042 true 2.063,0.948 2.417,1.146 0.354,0.198 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold (TWC: Front Catalyst).

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.