Home › Engine / Hybrid System › M20A-FKS (LUBRICATION) › ENGINE OIL COOLER › from 2021.02
RM33A0E _51 Engine / Hybrid System _098631 M20A-FKS LUBRICATION _0462222 ENGINE OIL COOLER A

M20A-FKS LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

w/ Filter:

i.

Install a new oil control valve filter to the cylinder block sub-assembly.



b.

Install 2 new oil cooler gaskets to the oil cooler assembly.


c.

Install the oil cooler assembly to the cylinder block sub-assembly with the 2 nuts and bolt.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


d.

Connect the No. 1 water by-pass hose and No. 2 water by-pass hose to the oil cooler assembly, and slide the 2 clips to secure them.


Hide 3.ADD ENGINE COOLANT

Hide 6.INSPECT FOR ENGINE OIL LEAK