Home › Engine / Hybrid System › M20A-FKS (STARTING) › RELAY › from 2021.02
RM33A0E _51 Engine / Hybrid System _098630 M20A-FKS STARTING _0462227 RELAY G

M20A-FKS STARTING  RELAY  INSPECTION  


PROCEDURE

Hide 28300 1.INSPECT ST RELAY

a.
E209082

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the ST relay.