44777
1.INSTALL NO. 1 VACUUM HOSE CONNECTOR
Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.
Check that there is no foreign matter on the connecting parts.
After connecting the No. 1 vacuum hose connector, check that the vacuum pump assembly and No. 1 vacuum hose connector are securely connected by pulling on them.
Connect the vacuum hose to the No. 1 vacuum hose connector.
44772
2.INSTALL CHECK VALVE TO CONNECTOR TUBE HOSE
Install the 2 clips to the check valve to connector tube hose.
| *a | Paint Mark |
Install the check valve to connector tube hose to the No. 1 hose to hose tube and slide the clip to secure it.
When connecting the check valve to connector tube hose, face the paint mark up.
Make sure that the tabs of the clip are facing upward.
44774
3.INSTALL UNION TO CONNECTOR TUBE HOSE
Install the 2 clips to the union to connector tube hose.
| *a | View A |
| *b | Paint Mark |
Install the union to connector tube hose to the No. 1 hose to hose tube and slide the clip to secure it.
When connecting the union to connector tube hose, face the paint mark up.
Make sure that the tabs of the clip are aligned as shown in the illustration.
44763A
4.INSTALL NO. 1 HOSE TO HOSE TUBE
Install the No. 1 hose to hose tube with the 2 nuts.
44772
5.CONNECT CHECK VALVE TO CONNECTOR TUBE HOSE
| *a | Paint Mark |
Connect the check valve to connector tube hose to the brake booster assembly and slide the clip to secure it.
When connecting the check valve to connector tube hose, face the paint mark up.
Make sure that the tabs of the clip are facing upward.
44774
6.CONNECT UNION TO CONNECTOR TUBE HOSE
| *a | Paint Mark |
Connect the union to connector tube hose to the No. 1 vacuum hose connector and slide the clip to secure it.
When connecting the union to connector tube hose, face the paint mark up.
Make sure that the tabs of the clip are facing the back of the vehicle.