Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for M20 Series Engine, BOSCH Made) › from 2021.02
RM33A0E _54 Brake _065366 BRAKE SYSTEM (OTHER) _0462489 VACUUM PUMP(for M20 Series Engine, BOSCH Made) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for M20 Series Engine, BOSCH Made)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

Refer to the following illustration and check which type is installed to the vehicle.

C449630C01
2.167,3.25 2,3.25 2,3.25 1.479,1.594 true 0.25,0.427 0.625,0.667 0.375,0.24 12 false *A 3.667,0.427 4.042,0.667 0.375,0.24 12 false *B 2.219,3.167 2.531,3.365 0.313,0.198 10 false *a
*A for BOSCH Made *B except BOSCH Made
*a Mark - -



PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 44777 2.DISCONNECT NO. 1 VACUUM HOSE CONNECTOR

a.
C411453C01
2.25,4.198 2.333,4.198 2.333,4.198 2.542,3.771 true 2.25,3.073 2.333,3.073 2.333,3.073 2.531,3.49 true 2.104,4.115 2.417,4.271 0.313,0.156 10 false *a 2.104,2.99 2.417,3.146 0.313,0.156 10 false *a
*a Retainer
V100135

Pinch
V113148

Pull off


Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.

NOTICE:

Be sure to disconnect the No. 1 vacuum hose connector by hand.



Hide 82121 3.SEPARATE ENGINE WIRE

a.
C411454

Disconnect the connector.


b.

Remove the bolt, 2 nuts and separate the engine wire.


c.
C411455

Disconnect the 2 connectors and disengage the clamp.


d.
C411456

Disconnect the 6 connectors and disengage the 2 clamps.


e.
C411457

Disconnect the connector and disengage the clamp.


Hide 29300 4.REMOVE VACUUM PUMP ASSEMBLY

a.

Move aside the engine wire.

NOTICE:

Do not apply excessive force to the engine wire.



b.
C411458

Using an 8 mm socket wrench, remove the 3 bolts and vacuum pump assembly from the engine assembly.


c.
C401028

Remove the No. 1 vacuum pump O-ring from the vacuum pump assembly.