This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Refer to the following illustration and check which type is installed to the vehicle.
| *A | for BOSCH Made | *B | except BOSCH Made |
| *a | Mark | - | - |
12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
44777
2.DISCONNECT NO. 1 VACUUM HOSE CONNECTOR
| *a | Retainer |
|
Pinch |
|
Pull off |
Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.
Be sure to disconnect the No. 1 vacuum hose connector by hand.
82121
3.SEPARATE ENGINE WIRE
Disconnect the connector.
Remove the bolt, 2 nuts and separate the engine wire.
Disconnect the 2 connectors and disengage the clamp.
Disconnect the 6 connectors and disengage the 2 clamps.
Disconnect the connector and disengage the clamp.
29300
4.REMOVE VACUUM PUMP ASSEMBLY
Move aside the engine wire.
Do not apply excessive force to the engine wire.
Using an 8 mm socket wrench, remove the 3 bolts and vacuum pump assembly from the engine assembly.
Remove the No. 1 vacuum pump O-ring from the vacuum pump assembly.