CUSTOMIZE PARKING SUPPORT BRAKE SYSTEM
Customizing with the GTS.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Warning / Utility / Customize Setting.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| PKSB (O) Function | Parking support brake (static objects) function setting | ON | $00:ON,$01:OFF | Clearance warning ECU assembly |
| PKSB (O) Target Stopping Distance | Stop distance status of parking support brake (static objects) function | Far | $00:Close,$01:Far | Clearance warning ECU assembly |
| PKSB Switch State Stored | Setting of the parking support brake system main switch status memory | Stored | $00:Stored,$01:Not Stored | Clearance warning ECU assembly |
| PKSB (V) Function | Parking support brake (rear crossing vehicles) function setting | ON | $00:ON,$01:OFF | Clearance warning ECU assembly |