DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Warning / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Ultrasonic Sensor (Front Left Center) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Front Left Center) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Front Right Center) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Front Right Center) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Front Left Corner) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Front Left Corner) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Front Right Corner) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Front Right Corner) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Left Center) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Left Center) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Right Center) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Right Center) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Left Corner) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Left Corner) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Right Corner) Target Distance - First Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| Ultrasonic Sensor (Rear Right Corner) Target Distance - Second Wave | Distance from the ultrasonic sensor to the target | Unknown/Not Detected/0 to 7.65 m | Unknown: Outside sensor operation conditions
Not detected: Not detected 0 to 7.65 m: Detected distance |
- |
| PKSB Main Switch | Input signal for parking support brake system | ON/OFF | ON: Parking support brake system ON
OFF: Parking support brake system OFF |
- |
| PKSB (O) Function | Status of parking support brake (static objects) function | ON/OFF | ON: Parking support brake (static objects) function ON
OFF: Parking support brake (static objects) function OFF |
- |
| PKSB (O) Target Stopping Distance | Target stop distance setting status of parking support brake (static objects) function | Close/Far | Setting of customized parameter | - |
| PKSB Switch State Stored | Setting of the parking support brake system main switch status memory | Stored/Not stored | Setting of customized parameter | - |
| PKSB (V) Function | Status of parking support brake (rear crossing vehicles) function | ON/OFF | ON: Parking support brake (rear crossing vehicles) function ON
OFF: Parking support brake (rear crossing vehicles) function OFF |
- |
| PKSB Detection Area Adjustment Incomplete | Adjustment status of ultrasonic sensor | Adjusted/Not Adjusted | Adjusted: Ultrasonic sensor adjustment complete
Not Adjusted: Ultrasonic sensor adjustment not complete |
- |
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Brake/EPB / Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Stop Lamp Relay | Stop lights | ON / OFF | Test possible at vehicle speed of 0 km/h (0 mph) |
According to the display on the GTS, perform the Active Test.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| ICS OFF Warning | Combination meter assembly | ON / OFF | - |
Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Buzzer | No. 1 clearance warning buzzer | Stop or Operate | Confirm that the vehicle is stopped and the ignition switch is ON |