Home › Engine / Hybrid System › M20A-FKS (FUEL) › FUEL PRESSURE SENSOR › from 2021.02
RM33A0E _51 Engine / Hybrid System _098628 M20A-FKS FUEL _0462958 FUEL PRESSURE SENSOR A

M20A-FKS FUEL  FUEL PRESSURE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89458H 1.INSTALL NO. 2 FUEL PRESSURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Install a new O-ring to the No. 2 fuel pressure sensor.


b.

Install the No. 2 fuel pressure sensor to the fuel delivery pipe sub-assembly.


c.

Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the No. 2 fuel pressure sensor connector.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION