Home › Engine / Hybrid System › M20A-FKS (FUEL) › FUEL TANK › from 2021.02
RM33A0E _51 Engine / Hybrid System _098628 M20A-FKS FUEL _0462963 FUEL TANK A

M20A-FKS FUEL  FUEL TANK  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Gas leak from exhaust system is repaired Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

·
A344817

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 2.DRAIN FUEL

Hide 17420 3.REMOVE CENTER EXHAUST PIPE ASSEMBLY

Hide 77641A 4.REMOVE NO. 1 FUEL TANK PROTECTOR

a.
A406574C01
1.719,3.104 2.063,3.104 true 1.531,3.01 1.729,3.177 0.198,0.167 10 true *a
*a Needle Nose Pliers


Using needle nose pliers, remove the 4 clips and No. 1 fuel tank protector from the fuel tank assembly.


Hide 77754B 5.DISCONNECT CHARCOAL CANISTER OUTLET HOSE

a.
A405928

Disconnect the charcoal canister outlet hose from the No. 6 fuel tank breather tube.


Hide 77213E 6.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.
A405931

Loosen the clamp, then disconnect the fuel tank to filler pipe hose from the fuel tank assembly.


Hide 77026A 7.DISCONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY

a.
A405933

Slide the clip and disconnect the No. 1 fuel evaporation tube sub-assembly from the fuel pipe.


Hide 77209F 8.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A405927

Disconnect the fuel tank main tube sub-assembly from the fuel pipe.

Click hereEngine / Hybrid System>M20A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 77100 9.REMOVE FUEL TANK ASSEMBLY

CAUTION:

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.


a.
A405929

Loosen the clamp, then disconnect the fuel tank breather tube sub-assembly from the fuel tank inlet pipe sub-assembly.


b.
A401817

Support the fuel tank assembly using an engine lifter.

HINT:

Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.



c.
A406576

Remove the 4 bolts, No. 1 fuel tank band sub-assembly LH and No. 1 fuel tank band sub-assembly RH.


d.

Lower the engine lifter to remove the fuel tank assembly.

NOTICE:
·

Be careful not to drop the fuel tank assembly.

·

When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.




Hide 77209F 10.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A405935

Disengage the clamp to remove the fuel tank main tube sub-assembly from the fuel tank assembly.


Hide 77754B 11.REMOVE CHARCOAL CANISTER OUTLET HOSE

a.
A405936

Disengage the clamp to remove the charcoal canister outlet hose from the fuel tank assembly.


Hide 77026A 12.REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY

a.
A405937

Disengage the clamp to remove the No. 1 fuel evaporation tube sub-assembly from the fuel tank assembly.


Hide 77656B 13.REMOVE NO. 6 FUEL TANK CUSHION

a.
A405938

Remove the No. 6 fuel tank cushion from the fuel tank assembly.


Hide 77652A 14.REMOVE NO. 2 FUEL TANK CUSHION

a.
A405939

Remove the 2 No. 2 fuel tank cushions from the fuel tank assembly.