Home › Engine / Hybrid System › M20A-FKS (FUEL) › FUEL SENDER GAUGE ASSEMBLY › from 2021.02
RM33A0E _51 Engine / Hybrid System _098628 M20A-FKS FUEL _0462964 FUEL SENDER GAUGE ASSEMBLY A

M20A-FKS FUEL  FUEL SENDER GAUGE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 83320 2.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A502678C01
0.104,2.438 0.479,2.677 0.375,0.24 12 false *B 0.073,0.073 0.448,0.313 0.375,0.24 12 false *A
*A for Type A
*B for Type B


Disconnect the fuel sender gauge assembly connector.


b.

Disengage the 2 clamps to disconnect the wire harness from the fuel suction plate sub-assembly.

NOTICE:
·

Do not damage the wire harness.

·

When disengaging each wire harness from the clamp, disengage one wire at a time.




c.
A502679

Disengage the claw to remove the fuel sender gauge assembly from the fuel sub-tank.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.