Home › Engine / Hybrid System › M20A-FKS (EMISSION CONTROL) › PURGE VALVE › from 2021.02
RM33A0E _51 Engine / Hybrid System _098629 M20A-FKS EMISSION CONTROL _0463336 PURGE VALVE A

M20A-FKS EMISSION CONTROL  PURGE VALVE  INSTALLATION  


PROCEDURE

Hide 25860 1.INSTALL PURGE VALVE (PURGE VSV)

a.
A443130C01
2,1.365 2.073,1.729 2.073,1.729 2.271,1.729 true 0.719,1.271 1.333,1.271 true 2.385,1.656 2.656,1.948 0.271,0.292 10 true *1 0.427,1.198 0.646,1.396 0.219,0.198 10 true *2 1.896,3.021 2.292,3.375 0.396,0.354 10 false *a 1.156,3.958 1.458,4.198 0.302,0.24 10 false *b
*1 No. 1 Fuel Vapor Feed Hose
*2 No. 2 Fuel Vapor Feed Hose
*a 120°
*b 2 to 7 mm (0.0787 to 0.276 in.)


Install the purge valve (purge VSV) to the purge VSV bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the No. 2 fuel vapor feed hose to the purge valve (purge VSV).


c.

Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.

HINT:

Engage the clip within the area shown in the illustration.



d.

Engage the wire harness clamp.


e.

Connect the purge valve (purge VSV) connector.