Home › Engine / Hybrid System › M20A-FKS (ENGINE MECHANICAL) › DRIVE BELT › from 2021.02
RM33A0E _51 Engine / Hybrid System _098627 M20A-FKS ENGINE MECHANICAL _0463496 DRIVE BELT G

M20A-FKS ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A345137

To prevent injury due to contact with an operating V-ribbed belt or cooling fan, keep your hands and clothing away from the V-ribbed belt and cooling fans when working in the engine compartment with the engine running or the ignition switch ON.


PROCEDURE

Hide 16361A 1.INSPECT V-RIBBED BELT

a.
A312661

Check the V-ribbed belt for wear, cracks or other signs of damage.

HINT:

If any of the following defects is found, replace the V-ribbed belt.

·

The V-ribbed belt is cracked.

·

The V-ribbed belt is worn out to the extent that the cords are exposed.

·

The V-ribbed belt has chunks missing from the ribs.




b.
A312662C01
0.448,1.542 0.76,1.698 0.313,0.156 10 false *a 2.167,1.531 2.479,1.688 0.313,0.156 10 false *b
*a Correct
*b Incorrect


Check that the V-ribbed belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.