Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › from 2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0329553 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0140  Lost Communication with Body Control Module  U0163  Lost Communication with Navigation Control Module  U0233  Lost Communication with Blind Spot Monitor Master Module  U1110  Lost Communication with Intuitive Parking Assist Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" Lost Communication with ECM CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with steering sensor CAN communication system
U0140 Lost Communication with Body Control Module Lost communication with main body ECU (multiplex network body ECU) CAN communication system
U0163 Lost Communication with Navigation Control Module Lost communication with radio and display receiver assembly CAN communication system
U0233 Lost Communication with Blind Spot Monitor Master Module Lost communication with blind spot monitor sensor RH CAN communication system
U1110 Lost Communication with Intuitive Parking Assist Module Lost communication with clearance warning ECU assembly CAN communication system

PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Chassis > Parking Assist Camera > Clear DTCs
50002 85

b.

Recheck for DTCs and check that no DTCs are output.

Chassis > Parking Assist Camera > Trouble Codes
50001 85
HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Result:
Result Proceed to
DTCs are output A
No DTCs are output B



A

B