86461
1.INSTALL FORWARD RECOGNITION HOOD
|
Inner Surface of Forward Recognition Hood |
Do not touch the inner surface of the forward recognition hood.
Do not apply force to the heating element of the forward recognition hood or an open circuit may result.
|
Heater Area |
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the 2 guides and 2 claws as indicated by the arrows in the order shown in the illustration.
Make sure that the 2 claws are engaged as shown in the illustration. Failure to do so may result in the malfunction of systems that use the forward recognition camera.
Do not apply force to the heating element of the forward recognition hood or an open circuit may result.
| *a | Connector Clamp |
| *b | Wire Harness Clamp |
|
Marking Tape |
With the marking tape of the wire harness in between the 2 wire harness clamps, engage the 2 wire harness clamps in the order shown in the illustration.
Do not forcibly pull the wire harness as it may become damaged.
As the No. 1 forward recognition cover cannot be installed correctly if the wire harness clamps are not engaged securely, make sure to engage the wire harness clamps securely.
Engage the connector clamp to install the forward recognition hood.
As the No. 1 forward recognition cover cannot be installed correctly if the connector clamp is not engaged securely, make sure to engage the connector clamp securely.
Connect the connector.
8646C
2.INSTALL FORWARD RECOGNITION CAMERA