The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | While the ignition switch is ON and the cruise control system is operating, signals cannot be received from the skid control ECU (brake actuator assembly) for 2.65 seconds or more. | ·
CAN communication system ·
ECM ·
Skid control ECU (brake actuator assembly) |
Refer to troubleshooting in CAN Communication System.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the ignition switch to ON.
Turn the cruise control system on using the cruise control main switch.
Wait for 3 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U012287 is not output | A |
| DTC U012287 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING