This DTC is stored when the vehicle stability control system has a problem. Check the vehicle stability control system when DTC P157800 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P157800 | Brake System | While the ignition switch is ON and the cruise control system is operating, a malfunction in the vehicle stability control system is detected for 0.2 seconds or more. | ·
Vehicle stability control system ·
ECM |
Before replacing the ECM, refer to Service Bulletin.
Check for DTCs.
Vehicle stability control system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
w/o Electric Parking Brake System: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
w/ Electric Parking Brake System: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the ignition switch to ON.
Turn the cruise control system on using the cruise control main switch.
Wait for 1 second or more.
Check for DTCs.
DTC P157800 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ECM>COMPONENTS
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>ECM>COMPONENTS
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>ECM>REMOVAL