Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0463554 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P163081  Communication Error from VSC to ECM Invalid Serial Data Received  


DESCRIPTION

The skid control ECU (brake actuator assembly) sends signals such as brake request signals to the ECM. If an abnormal signal is detected, the ECM stores DTC P163081.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
P163081 Communication Error from VSC to ECM Invalid Serial Data Received When the dynamic radar cruise control system is operating, the ECM detects abnormal data sent from the skid control ECU (brake actuator assembly) for approximately 1 second or more.
·

Vehicle stability control system

·

ECM


Cruise Control

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for vehicle stability control system DTCs.

Chassis > Brake > Trouble Codes
50001 435

Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B



A

2.CHECK FOR DTCs (Radar Cruise1)

B

2.CHECK FOR DTCs (Radar Cruise1)
a.

Clear the DTCs.

Powertrain > Cruise Control > Clear DTCs
50002 374

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 374

Result:
Result Proceed to
DTC P163081 is not output A
DTC P163081 is output B



A

B