The forward recognition camera communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | When the dynamic radar cruise control system is operating, a communication malfunction between the ECM and forward recognition camera is detected for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U012587 | Lost Communication with Multi-axis Acceleration Sensor Module Missing Message | When the vehicle speed is 1 km/h (1 mph) or more, a communication error between the forward recognition camera and airbag sensor assembly continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication error between the forward recognition camera and steering sensor continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U012987 | Lost Communication with Brake System Control Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication error between the forward recognition camera and skid control ECU (brake actuator assembly) continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication error between the forward recognition camera and combination meter assembly continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U110687 | Lost Communication with Electric Parking Brake Module Missing Message | When the ignition switch is ON for 3 seconds or more, a communication error between the forward recognition camera and skid control ECU (brake actuator assembly) continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING