Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0463554 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U040181  Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received  


DESCRIPTION

If the ECM cannot recognize the forward recognition camera. DTC U040181 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U040181 Invalid Data Received from ECM/PCM "A" Invalid Serial Data Received Approximately 17 seconds or more after the ignition switch is turned to ON, the ECM cannot recognize the forward recognition camera for approximately 2 seconds or more. ECM Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTC (Radar Cruise2)
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 426

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Powertrain > Radar Cruise2 > Trouble Codes
50001 426

Result:
Result Proceed to
DTC U040181 is not output A
DTC U040181 is output B



A

B