Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2021.02
RM33A0E _58 Vehicle Interior _065384 PRE-COLLISION _0319645 PRE-COLLISION SYSTEM W

PRE-COLLISION  PRE-COLLISION SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE PRE-COLLISION SYSTEM


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



a.

Customizing with the Multi-information Display

i.

Turn the ignition switch to ON.


ii.

Select the setting by referring to the table below.


iii.

Using the steering pad switches, change the customize settings.

HINT:

Each item is displayed on the "Setting" tab on the multi-information display.


Pre-collision System Settings
Display Description Setting Default
PCS Turns the pre-collision system function on/off. ON/OFF ON
Sensitivity Sets the pre-collision system function warning sensitivity Early/Middle/Late Middle



b.

Customizing with the GTS

i.

Select the setting by referring to the table below.

Others
Tester Display Description Default Setting ECU
PCS Function ON/OFF State Stored Refer to the table below Not Stored $00:Not Stored,$01:Stored Forward recognition camera
PCS Warning Timing State Stored 1 Refer to the table below Not Stored $00:Not Stored,$01:Stored Forward recognition camera
PCS Warning Timing State Stored 2 Refer to the table below Stored $00:Not Stored,$01:Stored Forward recognition camera
PCS Warning Timing State Stored 3 Refer to the table below Not Stored $00:Not Stored,$01:Stored Forward recognition camera
50006 98
Measurement Item
Customize Setting Description Setting
PCS Function ON/OFF State Stored Function to maintain the pre-collision system on/off setting when the ignition switch is turned to ON from off. Not stored: Pre-collision system always turns on
Stored: Pre-collision system maintains previous setting
PCS Warning Timing State Stored 1 Function to set whether or not to store the warning sensitivity setting when the PCS function is turned from off to on while the ignition switch is ON. Not stored: Sensitivity setting is reset to Middle
Stored: Sensitivity settings are maintained as previous value
PCS Warning Timing State Stored 2 Function to set whether or not to store the warning sensitivity setting when the PCS function is on and the ignition switch is turned from off to ON. Not stored: Sensitivity setting is reset to Middle
Stored: Sensitivity settings are maintained as previous value
PCS Warning Timing State Stored 3 Function to set whether or not to store the warning sensitivity setting when the PCS function is off and the ignition switch is turned from off to ON. Not stored: Sensitivity setting is reset to Middle
Stored: Sensitivity settings are maintained as previous value