CHECK FORWARD RECOGNITION CAMERA
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.
Do not apply excessive force to the forward recognition camera connector.
| *A | Before Jan. 2022 Production | *B | From Jan. 2022 Production |
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| V6-7 (IGB) - V6-10 (GND) | LA-P - W-B*1
LA-P - LA*2 |
Power source | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| V6-10 (GND) - Body ground | W-B - Body ground*1
LA - Body ground*2 |
Ground | Always | Below 1 Ω |
*1: for RHD without Headup Display
*2: excpt RHD without Headup Display
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| V25-7 (IGB) - V25-10 (GND) | LA-P - W-B*1
LA-P - LA*2 |
Power source | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| V25-10 (GND) - Body ground | W-B - Body ground*1
LA - Body ground*2 |
Ground | Always | Below 1 Ω |
*1: for RHD without Headup Display
*2: excpt RHD without Headup Display