When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the ECM and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system |
| U012587 | Lost Communication with Multi-axis Acceleration Sensor Module Missing Message | While the vehicle is being driven at 5 km/h (4 mph) or more, a communication error between the airbag sensor assembly and the forward recognition camera is detected for approximately 4 seconds or more. | CAN communication system |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the steering sensor and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system |
| U012987 | Lost Communication with Brake System Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the skid control ECU (brake actuator assembly) and the forward recognition camera is detected for approximately 1 second or more. | CAN communication system |
| U013187 | Lost Communication with Power Steering Control Module Missing Message | 3 seconds after the ignition switch is turned to ON, a communication error between the power steering ECU (rack and pinion power steering gear assembly) and the forward recognition camera is detected for approximately 2 second or more. | CAN communication system |
Clear the DTCs.
Reproduce the vehicle conditions that were present when the DTCs that were noted were stored.
If the detection conditions are not met, the system cannot detect malfunctions.
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING