The forward recognition camera receives vehicle information (Conv/HV/EV) and vehicle information (transmission type) from the ECM via the CAN communication line.
When the forward recognition camera is unable to determine the vehicle information (Conv/HV/EV) and vehicle information (transmission type) from the vehicle information (Conv/HV/EV) and vehicle information (transmission type) sent from the ECM, the forward recognition camera outputs U030051.
When the vehicle information (Conv/HV/EV) and vehicle information (transmission type) sent from the ECM does not match the vehicle information stored by the forward recognition camera, the forward recognition camera outputs U030057.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U030051 | Internal Control Module Software Incompatibility Not Programmed | Once 3 seconds elapse after turning the ignition switch to ON, the system is unable to determine the vehicle information (Conv/HV/EV) and vehicle information (transmission type) sent from the ECM and vehicle information (Conv/HV/EV) and vehicle information (transmission type) sent from the forward recognition camera for approximately 3 seconds or more | ·
SFI system ·
Forward recognition camera ·
ECM |
| U030057 | Internal Control Module Software Incompatibility Invalid / Incompatible Software Component | Once 3 seconds elapse after turning the ignition switch to ON, the vehicle information (Conv/HV/EV) and vehicle information (transmission type) sent from the ECM does not match the vehicle information stored by the forward recognition camera for approximately 1 second or more | ·
SFI system ·
Forward recognition camera ·
ECM |
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
When the forward recognition camera is replaced with a new one or the windshield glass is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.
Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.
One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)
Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)
Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>DRIVING ADJUSTMENT
Before replacing the ECM, refer to Service Bulletin.
Check the DTCs.
If the pre-collision system outputs U030051 or U030057, SFI system DTCs may also have been output. Check the SFI system first.
SFI system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>DIAGNOSTIC TROUBLE CODE CHART
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Using the GTS, perform the Health Check.
Check for DTCs.
ECUs other than the forward recognition camera do not output specification information mismatch DTCs related to the ECM.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ECM>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>ECM>REMOVAL
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>ECM>REMOVAL
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Information (Conv/HV/EV) | Vehicle information (Conv/HV/EV) | Unknown / Conv / HV/EV | Unknown: Vehicle information not confirmed
Conv: Conventional HV/EV: Hybrid vehicle |
- |
| Vehicle Information (Transmission Type) | Vehicle information (transmission type) | MT, AT, CVT, MMT, SMT, HV/EV - AT or Unknown | Displays the type of transmission | - |
| Tester Display |
|---|
| Vehicle Information (Conv/HV/EV) |
| Vehicle Information (Transmission Type) |
When the specification stored by the forward recognition camera and the vehicle specification do not match, there is a malfunction in the specification information stored by the forward recognition camera. Therefore, replace the forward recognition camera.
When the specification stored by the forward recognition camera and the vehicle specification match, an ECM with different specifications may be installed. Therefore, replace the ECM.
| Result | Proceed to |
|---|---|
| Specification stored by the forward recognition camera and vehicle specification do not match | A |
| "Unknown" is displayed | |
| Specification stored by the forward recognition camera and vehicle specification match | B |
A
B
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ECM>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>ECM>REMOVAL
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>ECM>REMOVAL