Home › Audio / Visual / Telematics › TELEMATICS › TELEPHONE ANTENNA › from 2021.02
RM33A0E _56 Audio / Visual / Telematics _072211 TELEMATICS _0351483 TELEPHONE ANTENNA A

TELEMATICS  TELEPHONE ANTENNA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during roof antenna assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE ROOF HEADLINING ASSEMBLY

Hide 2.REMOVE ROOF ANTENNA ASSEMBLY WITH COVER

a.
E365398

Disconnect the connector.


b.
E365399

Remove the bolt.


c.
E365400C02
0,0 0,0 false
V113147

Remove in this Direction


Pull the washer and holder as shown in the illustration and remove the roof antenna assembly with cover.


Hide 86300J 3.REMOVE ROOF ANTENNA ASSEMBLY

a.
E365402C02
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull the roof antenna assembly in the direction indicated by the arrow (1) shown in the illustration to disengage the 3 claws and 2 guides.


b.

Pull the roof antenna assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the roof antenna assembly.


c.

When reusing the roof antenna assembly:

i.
E365404

for Type A:

1.

Remove the seal.