When TRC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred.
When a communication malfunction with the ECM is detected, TRC and VSC are disabled. Also, TRC and VSC are disabled when a DTC is stored.
When in VSC off mode, or TRC and VSC are disabled, the multi-information display in the combination meter assembly displays "Traction Control Turned Off" and the VSC OFF indicator light illuminates to inform the driver.
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Check whether the slip indicator light was illuminated when VSC did not operate.
The slip indicator light was illuminated.
When a DTC is stored, the slip indicator light is illuminated and VSC does not operate due to the fail-safe function.
Check whether the vehicle speed was 15 km/h (9 mph) or less when VSC did not operate.
The vehicle speed was 15 km/h (9 mph) or less.
VSC does not operate when the vehicle speed is 15 km/h (9 mph) or less.
Check whether the vehicle was driven straight for a few seconds at 15 km/h (9 mph) or more.
The vehicle was not driven straight for a few seconds at 15 km/h (9 mph) or more.
When the ignition switch is turned to ON, as steering angle sensor zero point calibration is not performed below 15 km/h (9 mph), VSC will not operate until the vehicle is driven straight for a few seconds at 15 km/h (9 mph) or more.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Brake/EPB / Trouble Codes.
Check the DTCs (vehicle stability control system) that are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| Vehicle stability control system DTCs are output | B |
A
B
Check that the tire of each wheel is the correct size.
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
The tire of each wheel is the correct size.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.
The yaw rate and acceleration sensor (airbag sensor assembly) is not installed in a tilted position.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
NG
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION