The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
These DTCs are stored when the skid control ECU (brake actuator assembly) receives a malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C00631F | Yaw Rate Sensor Circuit Intermittent | When the voltage at terminal +BS is between 9.6 and 16.5 V, data malfunction signal is received from the yaw rate sensor (airbag sensor assembly) for 1 second or more. | Yaw rate sensor (airbag sensor assembly) |
| C006396 | Yaw Rate Sensor Component Internal Failure | With the +BS terminal voltage between 9.6 and 16.5 V, a yaw rate sensor internal malfunction signal is received from the yaw rate sensor (airbag sensor assembly). | Yaw rate sensor (airbag sensor assembly) |
| C05201F | Multi-axis Acceleration Sensor Module "A" Circuit Intermittent | When the voltage at terminal +BS is between 9.6 and 16.5 V, data malfunction signal is received from the acceleration sensor (airbag sensor assembly) for 10 seconds or more. | Acceleration sensor (airbag sensor assembly) |
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Replace the yaw rate and acceleration sensor (airbag sensor assembly).
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT