Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2021.02
RM33A0E _54 Brake _065365 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0327182 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C05202A  Multi-axis Acceleration Sensor Module "A" Signal Stuck In Range  


DESCRIPTION

The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

The skid control ECU (brake actuator assembly) memorizes the range of the acceleration sensor (airbag sensor assembly) and the range of vehicle speed calculated using each speed sensor.

If the range of the acceleration sensor (airbag sensor assembly) and the range of vehicle speed calculated using each speed sensor are judged to be abnormal when compared to their past memorized range, this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C05202A Multi-axis Acceleration Sensor Module "A" Signal Stuck In Range The memorized range (longitudinal) of the acceleration sensor (airbag sensor assembly) is judged to be abnormal when compared to its past memorized range. Acceleration sensor (airbag sensor assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.REPLACE AIRBAG SENSOR ASSEMBLY
a.

Replace the yaw rate and acceleration sensor (airbag sensor assembly).

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL


Result:
Proceed to
NEXT



NEXT

END