Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2021.02
RM33A0E _54 Brake _065365 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0327182 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C052C11  ABS Pump Motor Control Circuit Short to Ground  C052C13  ABS Pump Motor Control Circuit Open  C052F14  ABS Pump Motor Supply Voltage Circuit Short to Ground or Open  C142719  ABS Pump Motor Circuit Current Above Threshold  


DESCRIPTION

The ABS motor relay is built into the brake actuator assembly.

When the skid control ECU (brake actuator assembly) operates ABS, TRC, VSC, brake hold or brake assist, the ABS motor relay turns ON and drives the motor pump built into the brake actuator assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
C052C11 ABS Pump Motor Control Circuit Short to Ground When the voltage at terminal +BM is between 9.6 and 16.4 V, a short to ground in the ABS motor drive circuit is detected during the self test. Skid control ECU (brake actuator assembly)
C052C13 ABS Pump Motor Control Circuit Open An open in the ABS motor drive circuit is detected during the self test. Skid control ECU (brake actuator assembly)
C052F14 ABS Pump Motor Supply Voltage Circuit Short to Ground or Open
·

When the pump motor is turned off after operating, 0.6 V or more is detected at the pump motor for 0.48 seconds or more.

·

The power supply of the ABS motor relay is less than 5 V for 0.15 seconds or more.


Skid control ECU (brake actuator assembly)
C142719 ABS Pump Motor Circuit Current Above Threshold
·

When the ABS motor relay is operating, an overload in the ABS motor relay is detected for 0.06 seconds or more.

·

When the ABS motor relay is operating, a short in the pump motor drive circuit is detected for 0.06 seconds or more.


Skid control ECU (brake actuator assembly)

DTC Detection Conditions: C052F14
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition The pump motor is turned off after operating. ○ -
Malfunction Status 0.6 V or more is detected at the pump motor. ○ -
The power supply of the ABS motor relay is less than 5 V. - ○
Detection Time 0.48 seconds or more. 0.15 seconds or more.
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


DTC Detection Conditions: C142719
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition The ABS motor relay is operating. ○ ○
Malfunction Status An overload in the ABS motor relay is detected. ○ -
A short in the pump motor drive circuit is detected. - ○
Detection Time 0.06 seconds or more. 0.06 seconds or more.
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.REPLACE BRAKE ACTUATOR ASSEMBLY

Result:
Proceed to
NEXT



NEXT

END