Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL BATTERY › from 2021.02
RM33A0E _58 Vehicle Interior _065378 DOOR LOCK _0327779 DOOR CONTROL BATTERY A

DOOR LOCK  DOOR CONTROL BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during door control battery removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY (for LHD)

Hide 8598A 2.REMOVE DOOR CONTROL BATTERY (for LHD)

a.
B607966

Remove the nut.


b.

Disengage the guide.


c.
B607965

Disconnect the connector to remove the door control battery.


Hide 73900 3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

Hide 8598A 4.REMOVE DOOR CONTROL BATTERY (for RHD)

a.
B607969

Remove the nut.


b.

Disengage the guide.


c.
B607968

Disconnect the connector to remove the door control battery.