84390B
1.INSPECT ECO SWITCH ASSEMBLY (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
| *a | Component without harness connected
(ECO Switch Assembly (Electric Parking Brake Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| K37-11 (ECU) - K37-16 (GND1) | ECO switch assembly (electric parking brake switch assembly) on (when switch is pressed) | Below 10 Ω |
| E37-11 (ECU) - K37-16 (GND1) | ECO switch assembly (electric parking brake switch assembly) off (when switch is not pressed) | 100 kΩ or higher |
Check that the switch illuminates.
Apply battery voltage to the ECO switch assembly (electric parking brake switch assembly) and check that the switch illuminates.
| Tester Connection | Specified Condition |
|---|---|
| Battery positive (+) → K37-3 (ILL+)
Battery negative (-) → K37-7 (ILL-) |
Illuminates |