73240
1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (DRIVER SEAT) (w/o Occupant Classification System)
| *a | Component without harness connected
(Front Seat Inner Belt Assembly (Driver Seat)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 2 | Driver side seat belt unfastened | Below 1 Ω |
| 3 - 2 | Driver side seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the front seat inner belt assembly (driver seat).
73240
2.INSPECT FRONT SEAT INNER BELT ASSEMBLY (FRONT PASSENGER SEAT) (w/o Occupant Classification System)
| *A | for LHD |
| *B | for RHD |
| *a | Component without harness connected
(Front Seat Inner Belt Assembly (Front Passenger Seat)) |
Measure the resistance according to the value(s) in the table below (seat belt warning switch).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R71-3 - R71-2 | Front passenger side seat belt unfastened | Below 1 Ω |
| Front passenger side seat belt fastened | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R70-3 - R70-2 | Front passenger side seat belt unfastened | Below 1 Ω |
| Front passenger side seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the front seat inner belt assembly (front passenger seat).
Measure the resistance according to the value(s) in the table below (occupant detection sensor line).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R71-5 - B-1 | Always | Below 1 Ω |
| R71-4 - B-3 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R70-5 - B-1 | Always | Below 1 Ω |
| R70-4 - B-3 | Always | Below 1 Ω |
If the result is not as specified, replace the front seat inner belt assembly (front passenger seat).