CHARGING SYSTEM PRECAUTION
Check that the battery cables are connected to the correct terminals.
Disconnect the battery cables when the battery is given a quick charge.
Do not perform tests with a high voltage insulation resistance tester.
Never disconnect the battery cables while the engine is running.
Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the engine room relay block and junction block assembly.
INITIALIZATION
Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the cable has been disconnected from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION