The combination meter assembly receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication. The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU (brake actuator assembly). The skid control ECU (brake actuator assembly) supplies power to the vehicle speed sensor. The skid control ECU (brake actuator assembly) detects vehicle speed signals based on pulses of the voltage.
Factors that affect the indicated vehicle speed include the tire size, tire inflation, and tire wear. The speed indicated on the speedometer has an allowable margin of error.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Before starting the following inspection, inspect the speedometer and check that the tire size and air pressure are as specified.
Tire size and air pressure: Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
Speedometer: Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>ON-VEHICLE INSPECTION
Check if CAN communication DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check if vehicle stability control system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Speedometer Operation (0km/h,0MPH) | Speedometer 0km/h (0mph) | ON | - |
| Speedometer Operation (40km/h,40MPH) | Speedometer 40 km/h (40 mph) | ON | The value displayed on the speedometer may deviate.
Reference km/h*1: 40 → 41.1 to 45.2 Reference km/h*2: 40 → 40.3 to 43.9 Reference km/h*3: 40 → 41.7 to 46.2 |
| Speedometer Operation (80km/h,80MPH) | Speedometer 80 km/h (80 mph) | ON | The value displayed on the speedometer may deviate.
Reference km/h*1: 80 → 82.2 to 86.3 Reference km/h*2: 80 → 81.4 to 85.0 Reference km/h*3: 80 → 83.4 to 88.4 |
| Speedometer Operation (120km/h,120MPH) | Speedometer 120 km/h (120 mph) | ON | The value displayed on the speedometer may deviate.
Reference km/h*1: 120 → 123.3 to 127.4 Reference km/h*2: 120 → 122.5 to 126.1 Reference km/h*3: 120 → 125.1 to 130.6 |
| Speedometer Operation (160km/h,160MPH) | Speedometer 160 km/h (160 mph) | ON | The value displayed on the speedometer may deviate.
Reference km/h*1: 160 → 164.4 to 168.5 Reference km/h*2: 160 → 163.6 to 167.2 Reference km/h*3: 160 → 166.2 to 173.2 |
| Speedometer Operation (200km/h,200MPH) | Speedometer 200 km/h (200 mph) | ON | The value displayed on the speedometer may deviate.
Reference km/h*1: 200 → 205.6 to 209.7 Reference km/h*2: 200 → 204.7 to 208.3 Reference km/h*3: 200 → 207.7 to 215.7 |
| Speedometer Operation (240km/h,240MPH) | Speedometer 240 km/h (240 mph) | ON | The value displayed on the speedometer may deviate.
Reference km/h*1: 240 → 246.7 to 250.8 Reference km/h*2: 240 → 245.8 to 249.4 Reference km/h*3: 240 → 249.2 to 258.0 |
*1: for RHD, Multi-information Display (7 Inch Display) without Front Fog Light
*3: for RHD, Multi-information Display (4.2 Inch Display) without Front Fog Light
*3: for LHD, RHD with Front Fog Light
| Tester Display |
|---|
| Speedometer Operation (0km/h,0MPH) |
| Tester Display |
|---|
| Speedometer Operation (40km/h,40MPH) |
| Tester Display |
|---|
| Speedometer Operation (80km/h,80MPH) |
| Tester Display |
|---|
| Speedometer Operation (120km/h,120MPH) |
| Tester Display |
|---|
| Speedometer Operation (160km/h,160MPH) |
| Tester Display |
|---|
| Speedometer Operation (200km/h,200MPH) |
| Tester Display |
|---|
| Speedometer Operation (240km/h,240MPH) |
Speedometer indication is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for RHD)>REMOVAL
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for LHD)>REMOVAL
NG