The main body ECU (multiplex network body ECU) controls the high beam headlights.
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the operation of the low beam headlights. If the low beam headlights do not operate normally, refer to Problem Symptoms Table.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*
*: w/ Smart Entry and Start System
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Head Light Hi | High beam headlights | OFF or ON | - |
| Tester Display |
|---|
| Head Light Hi |
High beam headlights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the DIM relay.
Click hereVehicle Exterior>LIGHTING (EXT)>RELAY>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (DIM relay) - Body ground | Always | 11 to 14 V |
| 5 (DIM relay) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K52 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (DIM relay) - K52-13 (DIM) | Always | Below 1 Ω |
| 1 (DIM relay) or K52-13 (DIM) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG