Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › from 2021.02
RM33A0E _56 Audio / Visual / Telematics _072211 TELEMATICS _0351443 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B15C511  Emergency Call Switch Circuit Short to Ground  B15C513  Emergency Call Switch Circuit Open  


DESCRIPTION

If the telematics transceiver detects an error in the communication between the telematics transceiver and the roof console box sub-assembly (manual (SOS) switch) as a result of the telematics transceiver self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C511 Emergency Call Switch Circuit Short to Ground Manual (SOS) switch impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Roof console box sub-assembly (manual (SOS) switch)

·

Harness or connector

·

Telematics transceiver


B15C513 Emergency Call Switch Circuit Open Manual (SOS) switch impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Roof console box sub-assembly (manual (SOS) switch)

·

Harness or connector

·

Telematics transceiver



WIRING DIAGRAM

E462869E02
0.573,2.073 0.969,2.26 0.396,0.188 10 false K156 5.031,2.052 5.427,2.24 0.396,0.188 10 false V20 0.563,2.24 2.76,2.479 2.198,0.24 10 false Telematics Transceiver 5.031,2.219 7.073,2.656 2.042,0.438 10 false Roof Console Box Sub-assembly (Manual (SOS) Switch) 5.375,0.792 5.771,0.979 0.396,0.188 10 false SIG1 5.396,1.594 5.823,1.781 0.427,0.188 10 false GND3 1.438,0.792 1.833,0.979 0.396,0.188 10 false SIG1 1.448,1.594 1.802,1.781 0.354,0.188 10 false SIG- 1.844,0.698 2.094,0.885 0.25,0.188 10 false 21 1.844,1.479 2.094,1.667 0.25,0.188 10 false 3 5.135,0.667 5.344,0.854 0.208,0.188 10 false 17 5.135,1.469 5.344,1.656 0.208,0.188 10 false 12

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>PRECAUTION

·

When replacing the telematics transceiver, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC OUTPUT
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

f.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
No DTCs are output. A
DTCs are output. B



A

B

2.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)
2.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)
a.
E360500C71
1.188,1.865 1.396,1.865 1.396,1.865 1.49,1.479 false 2.688,1.844 2.417,1.844 2.417,1.844 2.24,1.469 false 0.188,0.167 0.5,0.365 0.313,0.198 10 false *a 2.74,1.75 3.188,2 0.448,0.25 10 false GND3 0.854,1.792 1.302,2.042 0.448,0.25 10 false SIG1
*a Component without harness connected
(Roof Console Box Sub-assembly (Manual (SOS) Switch))


Remove the roof console box sub-assembly (manual (SOS) switch).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
17 (SIG1) - 12 (GND3) Manual (SOS) switch not operated 410 to 414 Ω
17 (SIG1) - 12 (GND3) Manual (SOS) switch operated 81 to 83 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))

NG

REPLACE ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))
a.

Disconnect the K156 telematics transceiver connector.


b.

Disconnect the V20 roof console box sub-assembly (manual (SOS) switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K156-21 (SIG1) - V20-17 (SIG1) Always Below 1 Ω
K156-3 (SIG-) - V20-12 (GND3) Always Below 1 Ω
K156-21 (SIG1) or V20-17 (SIG1) - Body ground Always 10 kΩ or higher
K156-3 (SIG-) or V20-12 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEMATICS TRANSCEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT