Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › from 2021.02
RM33A0E _54 Brake _065369 PARKING BRAKE _0328504 ELECTRIC PARKING BRAKE SYSTEM L

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

System See Procedure
Lane Tracing Assist System (Click here)
Pre-collision System
Parking Assist Monitor System
Panoramic View Monitor System



IGNITION SWITCH EXPRESSION


HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)



TROUBLESHOOTING PRECAUTIONS


a.

When inspecting the rear brakes, disconnect the connector or disconnect the cable from the negative (-) battery terminal in order to shut off the supply of electrical power.

CAUTION:
·

Do not perform the rear brake inspection while either the connector or the negative (-) battery terminal are connected.

·

The rear disc brake piston could operate, resulting in an accident such as hands being caught.




b.

The electric parking brake may still operate for 20 seconds* after the ignition switch is turned off.

*: The electric parking brake may still operate up to 60 minutes depending on the state of the vehicle after the ignition switch is turned off, so be sure to perform the work procedures with the vehicle on a level surface.



c.

When any parts have been removed or installed, check for DTCs after completion of installation to confirm that the system is operating correctly.

HINT:

After performing work procedures such as installation, if the parking brake indicator light (red) is blinking, the parking brake must be released.




HANDLING PRECAUTIONS


a.

When tilting the vehicle to perform work after parking the vehicle on a level surface, the braking force may not be sufficient. Make sure to operate the electric parking brake switch to the lock side 2 times.

HINT:
·

When the parking brake indicator light is illuminated after the electric parking brake switch has been operated to the lock side (first time), the maximum amount of braking force is applied if the electric parking brake switch is operated to the lock side one more time (second time).

·

The electric parking brake system determines the amount of force used to operate the parking brake according to the tilt angle detected by the acceleration sensor (airbag ECU assembly).




b.

After replacing the skid control ECU (brake actuator assembly), the parking brake indicator light blinks when the ignition switch is turned to ON for the first time. To turn off the parking brake indicator light after replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch to the lock side then to the release side.



PRECAUTIONS FOR TOWING VEHICLES


a.

For towing precautions: Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PARKING BRAKE FORCED RELEASE METHOD


a.

For the parking brake forced release method: Click hereBrake>PARKING BRAKE>FORCED RELEASE>OPERATION METHOD