Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (w/o Occupant Classification System) › from 2021.02
RM33A0E _58 Vehicle Interior _065386 SEAT BELT _0327396 SEAT BELT WARNING SYSTEM(w/o Occupant Classification System) W

SEAT BELT  SEAT BELT WARNING SYSTEM(w/o Occupant Classification System)  CUSTOMIZE PARAMETERS  


CUSTOMIZE SEAT BELT WARNING SYSTEM (w/o Occupant Classification System)


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.

·

These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).



a.

Customizing with the GTS

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Customize Setting / Warning.


v.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
Driver Seatbelt Warning Buzzer Function Enables sounding of the driver seat belt warning buzzer ON $00:OFF,$01:ON Combination meter assembly
Passenger Seatbelt Warning Buzzer Function Enables sounding of the front passenger seat belt warning buzzer ON $00:OFF,$01:ON Combination meter assembly
Rear Right Seatbelt Warning Buzzer Function Function to sound the rear RH seat belt warning buzzer ON $00:OFF,$01:ON Combination meter assembly
Rear Left Seatbelt Warning Buzzer Function Function to sound the rear LH seat belt warning buzzer ON $00:OFF,$01:ON Combination meter assembly
Rear Center Seatbelt Warning Buzzer Function Function to sound the rear center seat belt warning buzzer ON $00:OFF,$01:ON Combination meter assembly
50006 7
HINT:

This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.