The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front power seat switch removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
71868N
3.REMOVE FRONT SEAT FRONT CUSHION SHIELD
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD
w/o Vertical Adjuster:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
w/ Vertical Adjuster:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
84921B
5.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
84921A
6.REMOVE RECLINING POWER SEAT SWITCH KNOB
72714
7.REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET (w/ Vertical Adjuster)
84922C
8.REMOVE FRONT POWER SEAT SWITCH
w/o Vertical Adjuster:
Remove the 3 screws and front power seat switch from the front seat cushion shield.
w/ Vertical Adjuster:
Remove the 2 screws and front power seat switch from the front seat cushion shield.