The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during upper seat track rail sub-assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY
89710C
2.REMOVE POSITION CONTROL ECU ASSEMBLY (w/ Seat Position Memory System)
71868N
3.REMOVE FRONT SEAT FRONT CUSHION SHIELD
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD (w/ Vertical Adjuster)
71811D
5.REMOVE FRONT SEAT CUSHION SHIELD (w/o Vertical Adjuster)
72108
6.REMOVE UPPER SEAT TRACK RAIL SUB-ASSEMBLY (w/ Vertical Adjuster)
| *a | 80 mm (3.15 in.) |
In order to reduce the risk of damage to the part and to ensure ease of operations, secure a space of 80 mm (3.15 in.) or more as shown in the illustration.
Secure enough space to ensure that the upper seat track rail sub-assembly does not contact any other objects during installation.
Disconnect the slide motor connector.
Disengage the claw and 2 clamps.
Remove the 2 screws.
|
Remove in this direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws.
Disengage the guide to remove the front seat cushion wire harness holder as shown in the illustration.
When remove the front seat cushion wire harness holder, take care not to damage each connector and wire harness.
|
Remove in this direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
Disengage the guide to remove the front seat lower cushion shield LH from the upper seat track rail sub-assembly as shown in the illustration.
| *a | Clamp |
| *b | Guide |
|
Remove in this direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
Disengage the clamp.
Disengage the guide to remove the front seat lower cushion shield RH from the upper seat track rail sub-assembly as shown in the illustration.
|
Remove in this direction |
|
Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
Disengage the guide to remove the front seat lower cushion shield from the upper seat track rail sub-assembly as shown in the illustration.
Disengage the clamp.
Remove the 8 nuts and upper seat track rail sub-assembly.
Do not reuse the upper seat track rail sub-assembly.
72106B
7.REMOVE UPPER SEAT TRACK RAIL SUB-ASSEMBLY (w/o Vertical Adjuster)
| *a | 80 mm (3.15 in.) |
In order to reduce the risk of damage to the part and to ensure ease of operations, secure a space of 80 mm (3.15 in.) or more as shown in the illustration.
Secure enough space to ensure that the upper seat track rail sub-assembly does not contact any other objects during installation.
Disconnect the slide motor connector.
Remove the 5 nuts and upper seat track rail sub-assembly.
Do not reuse the upper seat track rail sub-assembly.