The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seatback heater assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
71868N
3.REMOVE FRONT SEAT FRONT CUSHION SHIELD
71811D
4.REMOVE FRONT SEAT CUSHION SHIELD (w/o Vertical Adjuster)
71861
5.REMOVE FRONT SEAT INNER CUSHION SHIELD (w/o Vertical Adjuster)
71812D
6.REMOVE FRONT SEAT CUSHION SHIELD (w/ Vertical Adjuster)
71862
7.REMOVE FRONT SEAT INNER CUSHION SHIELD (w/ Vertical Adjuster)
8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71931
9.REMOVE FRONT SEAT HEADREST SUPPORT
10.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
71074S
11.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
87510N
12.REMOVE FRONT SEATBACK HEATER ASSEMBLY
Remove the 24 tag pins and front seatback heater assembly from the separate type front seatback cover.