Home › General › MAINTENANCE › A25A-FKS BATTERY › from 2021.02
RM33A0E _V1 General _065356 MAINTENANCE _0328822 A25A-FKS BATTERY A

MAINTENANCE  A25A-FKS BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the battery, use a new battery of the same dimensions with a capacity of 70 Ah or more at a 20-hour rate.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.
A402148

Loosen the nut, and disconnect the cable from the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 28800 3.REMOVE BATTERY

a.
A402149C01
0.656,0.323 0.969,0.479 0.313,0.156 10 false *a
*a Side View of Claws
V113146

Push Battery Terminal Cap Here
V113147

Push


Disengage the 2 claws as shown in the illustration and remove the battery terminal cap from the positive (+) battery terminal.


b.
A402150

Loosen the nut and disconnect the cable from the positive (+) battery terminal.


c.
A402151

Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly.


d.

Remove the battery from the vehicle.