Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Driver Side) › from 2021.02
RM33A0E _58 Vehicle Interior _065383 SUPPLEMENTAL RESTRAINT SYSTEMS _0327342 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  INSTALLATION  


PROCEDURE

Hide 73900 1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B490691C01
0.865,2.094 0.427,2.094 true 2.49,0.875 2.313,1.229 2.313,1.229 2.063,1.229 true 0.24,1.99 0.427,2.208 0.188,0.219 10 true *a 1.885,1.135 2.198,1.292 0.313,0.156 10 false *b
*a Airbag Connector
*b Airbag Connector Locking Button
V113147

Push in this Direction


Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



d.

Push in the airbag connector locking button to install the airbag connector.


e.
B490692

Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly.


f.

Engage the 2 claws.


g.

Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



Hide 73900 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B474870C02
2.479,0.875 2.219,1.208 2.219,1.208 2.031,1.208 true 2.51,2.313 2.51,3.031 true 2.438,3.063 2.656,3.25 0.219,0.188 10 true *a 1.854,1.135 2.167,1.292 0.313,0.156 10 false *b
*a Airbag Connector
*b Airbag Connector Locking Button
V113147

Push in this Direction


Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



d.

Push in the airbag connector locking button to install the airbag connector.


e.
B474868

Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly.


f.

Engage the 2 claws.


g.

Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



Hide 55434B 3.INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

Hide 55435B 4.INSTALL NO. 1 METER HOOD CLUSTER

Hide 55302D 5.INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY

Hide 53601 6.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55436B 7.INSTALL NO. 2 METER HOOD CLUSTER

Hide 55606 8.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 55606 9.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

Hide 62312B 11.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 62112A 12.INSTALL COWL SIDE TRIM SUB-ASSEMBLY

Hide 67914 13.INSTALL FRONT DOOR SCUFF PLATE

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

for M20A-FKS: Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>INSTALLATION

for A25A-FKS: Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION

for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION