The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat airbag assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
1.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
2.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
71074S
3.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Power Seat)
71074S
4.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Manual Seat)
72495
5.REMOVE VERTICAL ADJUSTING HANDLE (for Manual Seat with Vertical Adjuster)
72552B
6.REMOVE RECLINING HINGE COVER (for Manual Seat)
72526
7.REMOVE RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat)
71849
8.REMOVE SEAT ADJUSTER COVER CAP (for Manual Seat with Vertical Adjuster)
71868N
9.REMOVE FRONT SEAT FRONT CUSHION SHIELD (for Power Seat)
71812D
10.REMOVE FRONT SEAT CUSHION SHIELD (for Power Seat)
w/o Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
w/ Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
71812D
11.REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat)
w/o Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
w/ Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
71862
12.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Power Seat)
w/o Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
w/ Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
71862
13.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Manual Seat)
w/o Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
w/ Vertical Adjuster: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
14.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Power Seat)
15.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Manual Seat)
71931
16.REMOVE FRONT SEAT HEADREST SUPPORT (for Power Seat)
71931
17.REMOVE FRONT SEAT HEADREST SUPPORT (for Manual Seat)
18.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)
19.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)
73920A
20.REMOVE FRONT SEAT AIRBAG ASSEMBLY
|
Deployment Side |
When storing the front seat airbag assembly, keep the airbag deployment side facing upward.
for Type A:
Disengage the clamp.
Remove the 2 nuts and front seat airbag assembly.
Do not reuse the nuts.
Make sure that the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.
for Type B:
Disengage the clamp.
Remove the 2 nuts and front seat airbag assembly.
Do not reuse the nuts.
Make sure that the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.