The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering wheel assembly removal/installation are shown below.
Do not remove/install the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the ignition switch ON.
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE HORN BUTTON ASSEMBLY
3.REMOVE STEERING WHEEL ASSEMBLY
Disconnect each connector from the spiral cable with sensor sub-assembly.
w/ Steering Heater:
Disconnect the steering heater connector.
Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.
| *a | Matchmark |
Put matchmarks on the steering wheel assembly and steering main shaft.
Temporarily install the steering wheel assembly set bolt.
Do not overtighten the steering wheel assembly set bolt.
| *a | Turn |
| *b | Hold |
Using SST, separate the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
Remove the steering wheel assembly set bolt and steering wheel assembly.
84250A
4.REMOVE STEERING PAD SWITCH ASSEMBLY
84610F
5.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)
for UA80E: Click hereDrivetrain>UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT PADDLE SWITCH>REMOVAL
for UB80E: Click hereDrivetrain>UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT PADDLE SWITCH>REMOVAL
84523
6.REMOVE NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)
for UA80E: Click hereDrivetrain>UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT PADDLE SWITCH>REMOVAL
for UB80E: Click hereDrivetrain>UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT PADDLE SWITCH>REMOVAL