Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR › from 2021.02
RM33A0E _58 Vehicle Interior _065386 SEAT BELT _0328334 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during occupant detection sensor (separate type front seat cushion pad) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



HINT:
·

Use the same procedure for the RHD side and LHD side.

·

The following procedure is for the LHD side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL


Hide 2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL


Hide 73240 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY

Hide 71074S 4.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Manual Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 72495 5.REMOVE VERTICAL ADJUSTING HANDLE (for Manual Seat)

w/ Vertical Adjuster:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 72552B 6.REMOVE RECLINING HINGE COVER (for Manual Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 72526 7.REMOVE RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 71849 8.REMOVE SEAT ADJUSTER COVER CAP (for Manual Seat)

w/ Vertical Adjuster:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 71811D 9.REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat)

w/o Vertical Adjuster:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


w/ Vertical Adjuster:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 71861 10.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Manual Seat)

w/o Vertical Adjuster:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


w/ Vertical Adjuster:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 11.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Manual Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


Hide 71074S 12.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER (for Power Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY


Hide 71868N 13.REMOVE FRONT SEAT FRONT CUSHION SHIELD (for Power Seat)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY


Hide 71812D 14.REMOVE FRONT SEAT CUSHION SHIELD (for Power Seat)

Hide 71862 15.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Power Seat)

Hide 16.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (for Power Seat)

w/o Front Seat Side Airbag:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY


w/ Front Seat Side Airbag:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY


Hide 17.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

for Manual Seat:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY


for Power Seat:

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY


Hide 71512S 18.REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)

a.

Using a screwdriver, disengage the 14 claws and remove the occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover as shown in the illustration.

B471094C02
1.583,2.427 1.99,2.427 false 2.031,2.323 2.344,2.479 0.313,0.156 10 false *a
*a Screwdriver - -



Hide 87510L 19.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)

HINT:

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>REMOVAL