The illuminated entry system controls the engine switch illumination.
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.*
*: w/ Smart Entry and Start System
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Entry&Start / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Engine switch illumination | OFF or ON | - |
| Tester Display |
|---|
| Power/Engine SW Light |
Engine switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the engine switch.
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (STARTING)>ENGINE SWITCH>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (STARTING)>ENGINE SWITCH>REMOVAL
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (STARTING)>ENGINE SWITCH>REMOVAL
Inspect the engine switch.
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (STARTING)>ENGINE SWITCH>INSPECTION
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (STARTING)>ENGINE SWITCH>INSPECTION
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (STARTING)>ENGINE SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (STARTING)>ENGINE SWITCH>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (STARTING)>ENGINE SWITCH>REMOVAL
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (STARTING)>ENGINE SWITCH>REMOVAL
Disconnect the K62 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K63-9 (SWIL) - K62-10 (SWIL) | Always | Below 1 Ω |
| K63-6 (AGND) - K62-11 (AGND) | Always | Below 1 Ω |
| K63-9 (SWIL) or K62-10 (SWIL) - Body ground | Always | 10 kΩ or higher |
| K63-6 (AGND) or K62-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG