897A0
1.INSTALL DOOR CONTROL AND TIRE PRESSURE WARNING ECU AND RECEIVER (w/o Smart Entry and Start System)
Do not drop, strike or otherwise subject the door control and tire pressure warning ECU and receiver to impact.
If the door control and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
| *A | for Type A |
| *B | for Type B |
Connect the connector.
Engage the 2 guides and install the door control and tire pressure warning ECU and receiver with the bolt.
There are three types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.
897B0
2.INSTALL ELECTRICAL KEY AND TIRE PRESSURE WARNING ECU AND RECEIVER (w/ Smart Entry and Start System)
Do not drop, strike or otherwise subject the electrical key and tire pressure warning ECU and receiver to impact.
If the electrical key and tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
| *A | for Type A |
| *B | for Type B |
Connect the connector.
Engage the 2 guides and install the electrical key and tire pressure warning ECU and receiver with the bolt.
There are three types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.
62471A
3.INSTALL INNER ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
4.INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>INSTALLATION
62331A
5.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type)
72693
6.INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)
7.INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
73350C
8.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type)
9.INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Reclining Seat Type)
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>INSTALLATION
62331A
10.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Reclining Seat Type)
11.INSTALL REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type)
72996A
12.INSTALL REAR SEATBACK COVER (for Reclining Seat Type)
72693
13.INSTALL REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type)
14.INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)
73350C
15.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Reclining Seat Type)
71940A
16.INSTALL REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type)
17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag)
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION
for M20A-FKS:
18. REGISTER TRANSMITTER ID
19.INSPECT TIRE PRESSURE WARNING SYSTEM
20.PERFORM INITIALIZATION
21. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Rear Seat Side Airbag)
22.INSPECT SRS WARNING LIGHT (w/ Rear Seat Side Airbag)