Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Front Door) › from 2021.02
RM33A0E _59 Vehicle Exterior _065390 WINDOW / GLASS _0327253 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 85720D 2.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.


a.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:
5.39 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 3.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Hide 68102 4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 5.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 6.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL

Hide 67602 7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 81230 8.INSTALL COURTESY LIGHT ASSEMBLY

Hide 74220 9.INSTALL FRONT ARMREST ASSEMBLY

Hide 10.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 11.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 74038A 12.INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY

Hide 67492A 13.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 15.INITIALIZE POWER WINDOW CONTROL SYSTEM