Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
85720E
2.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
3.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY
68104
4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
68124B
5.INSTALL REAR DOOR QUARTER WINDOW GLASS
67408F
6.INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
67872
7.CONNECT REAR DOOR WEATHERSTRIP
68152C
8.INSTALL REAR DOOR GLASS RUN
67858B
9.INSTALL REAR DOOR PANEL PROTECTOR
67848A
10.INSTALL REAR DOOR NO. 1 VENT SEAL
67842E
11.INSTALL REAR DOOR SERVICE HOLE COVER
67844A
12.INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER
68174A
13.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
67604
14.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74260
15.INSTALL REAR ARMREST ASSEMBLY
16.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
74038B
17.INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION
for M20A-FKS:
19.INITIALIZE POWER WINDOW CONTROL SYSTEM
20.INSPECT POWER WINDOW OPERATION